to Bob Pease
Bob Pease was an expert analogue designer who developed seminal circuits that are still with us today. Our first tribute to Pease was our first ever Boldport Club project, and this current one is the last ‘monthly’ project.
This version uses a circuit around the LM331, also designed by Pease. It is a sinle voltage to frequency converter where the setting of the trimmer sets the output frequency that can be observed by the flashing LED. The frequency range using the multi-turn 2MΩ trimmer is about 3Hz to 300Hz.
The circuit itself appears in Application Report SNOA735B, Figure 2. One of the primary advantages of this arrangement is that the output isn’t affected (much) with the supply voltage. The Application Report details other advantages.
Assembly and usage
The project comes with the following components:
x1 LM331 IC, TI LM331N/NOPB
x1 N-channel MOSFET transistor, Fairchild 2N7000_D26Z
x1 5mm red LED, CREE C503B-RBS-CW0Z0AA1
x1 2MΩ trimmer, Suntan TSR-3296Y-205R
x6 15KΩ resistor, Multicomp MF25 15K
x2 16-pin IC socket, TruConnect 22-0107
x1 10µF electrolytic capacitor, Multicomp MCUMR16V106M4X5
x1 0.1uF, Suntan TS170R2A104KSBBA0R
x2 1uF, Suntan TS170R1H105MSBFA0R
x1 10-pin header, Multicomp MC34739
x1 Lovely PCB
Conveniently, the schematic is on the board itself! Follow this infographic for help. Two things to pay attention to in particular:
Place components on the right side! See the symbols on the PCB.
There’s an extra hole that we added to allow people to use other potentiometers. Unfortunately we wired it wrongly (it’s connected to ground). If you’re going to use the components we provided, then everything’s fine. If not, pay attention not to use this hole and potentially creating a power short.
Pease-out is an open source design, as is most of our work. You can find the design files for the hardware and packaging at our GitHub repository. You can edit the design files using our own PCB design open source software, PCBmodE.
The PCBs were lovingly made by Eurocircuits.
Community contributions for this project are on our community site.